You are viewing the version of this documentation from Perl 5.41.5. This is a development version of Perl.
syswrite FILEHANDLE,SCALAR,LENGTH,OFFSET
syswrite FILEHANDLE,SCALAR,LENGTH
syswrite FILEHANDLE,SCALAR

Attempts to write LENGTH bytes of data from variable SCALAR to the specified FILEHANDLE, using write(2). If LENGTH is not specified, writes whole SCALAR. It bypasses any PerlIO layers including buffered IO (but is affected by the presence of the :utf8 layer as described later), so mixing this with reads (other than sysread)), print, write, seek, tell, or eof may cause confusion because the :perlio and :crlf layers usually buffer data. Returns the number of bytes actually written, or undef if there was an error (in this case the errno variable $! is also set). If the LENGTH is greater than the data available in the SCALAR after the OFFSET, only as much data as is available will be written.

An OFFSET may be specified to write the data from some part of the string other than the beginning. A negative OFFSET specifies writing that many characters counting backwards from the end of the string. If SCALAR is of length zero, you can only use an OFFSET of 0.

WARNING: If the filehandle is marked :utf8, syswrite will raise an exception. The :encoding(...) layer implicitly introduces the :utf8 layer. Alternately, if the handle is not marked with an encoding but you attempt to write characters with code points over 255, raises an exception. See binmode, open, and the open pragma.