=over =item sysread FILEHANDLE,SCALAR,LENGTH,OFFSET X =item sysread FILEHANDLE,SCALAR,LENGTH Attempts to read LENGTH bytes of data into variable SCALAR from the specified FILEHANDLE, using L. It bypasses any L layers including buffered IO (but is affected by the presence of the C<:utf8> layer as described later), so mixing this with other kinds of reads, L|/print FILEHANDLE LIST>, L|/write FILEHANDLE>, L|/seek FILEHANDLE,POSITION,WHENCE>, L|/tell FILEHANDLE>, or L|/eof FILEHANDLE> can cause confusion because the C<:perlio> or C<:crlf> layers usually buffer data. Returns the number of bytes actually read, C<0> at end of file, or undef if there was an error (in the latter case L|perlvar/$!> is also set). SCALAR will be grown or shrunk so that the last byte actually read is the last byte of the scalar after the read. An OFFSET may be specified to place the read data at some place in the string other than the beginning. A negative OFFSET specifies placement at that many characters counting backwards from the end of the string. A positive OFFSET greater than the length of SCALAR results in the string being padded to the required size with C<"\0"> bytes before the result of the read is appended. There is no syseof() function, which is ok, since L|/eof FILEHANDLE> doesn't work well on device files (like ttys) anyway. Use L|/sysread FILEHANDLE,SCALAR,LENGTH,OFFSET> and check for a return value of 0 to decide whether you're done. Note that if the filehandle has been marked as C<:utf8>, C will throw an exception. The C<:encoding(...)> layer implicitly introduces the C<:utf8> layer. See L|/binmode FILEHANDLE, LAYER>, L|/open FILEHANDLE,MODE,EXPR>, and the L pragma. =back